Bara senzori linie digital QTR-8RC

Bara senzori linie digitali.

#include "qtrsensors.h"

#define NUM_SENSORS   8     // number of sensors used
#define TIMEOUT       2500  // waits for 2500 microseconds for sensor outputs to go low
#define EMITTER_PIN   2     // emitter is controlled by digital pin 2


QTRSensorsRC qtrrc((unsigned char[]) {
  3, 4, 5, 6, 7, 8, 9, 10}
,
NUM_SENSORS, TIMEOUT, EMITTER_PIN); 
unsigned int sensorValues[NUM_SENSORS];


void setup()
{
  delay(500);
  pinMode(13, OUTPUT);
  digitalWrite(13, HIGH);    
  for (int i = 0; i < 400; i++)  
  {
    qtrrc.calibrate();       
  }
  digitalWrite(13, LOW);     


  Serial.begin(9600);
  for (int i = 0; i < NUM_SENSORS; i++)
  {
    Serial.print(qtrrc.calibratedMinimumOn[i]);
    Serial.print(' ');
  }
  Serial.println();

 
  for (int i = 0; i < NUM_SENSORS; i++)
  {
    Serial.print(qtrrc.calibratedMaximumOn[i]);
    Serial.print(' ');
  }
  Serial.println();
  Serial.println();
  delay(1000);
}


void loop()
{
  // read calibrated sensor values and obtain a measure of the line position from 0 to 5000
  // To get raw sensor values, call:
  //  qtrrc.read(sensorValues); instead of unsigned int position = qtrrc.readLine(sensorValues);
  unsigned int position = qtrrc.readLine(sensorValues);

  // print the sensor values as numbers from 0 to 1000, where 0 means maximum reflectance and
  // 1000 means minimum reflectance, followed by the line position
  for (unsigned char i = 0; i < NUM_SENSORS; i++)
  {
    Serial.print(sensorValues[i]);
    Serial.print('t');
  }
  //Serial.println(); // uncomment this line if you are using raw values
  Serial.println(position); // comment this line out if you are using raw values

  delay(250);
}

Specificatii:
 

• Dimensiuni : 74.93 x 12.7 x 3.04 mm
• Tensiunea de alimentare : 3.3-5V
• Curent : 100mA
• Output : 8 digital pulse
• Distanta optima : 3mm
• Distanta maxima : 9 mm
• Greutate : 3.09 g

Linkuri:
 

Pagina producatorului